CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Alarm Module: Testing and Inspection
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the Supplemental Restraint System
before performing repairs or service.
1. Remove the passenger's seat.
2. Disconnect the 12P and 18P connectors from the security control unit.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, make the following input tests at the connector terminals.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the control unit must be faulty; replace it.
Security System:
