CL V6-3.2L SOHC (2002)
6. Reconnect the 3P and 20P connectors.
7. Check for voltage pulse between the No. 1 terminal of the slide position sensor and body ground when the slide motor moves forward or
backward.
Does voltage pulse from 0 to about 5 V alternately?
YES - Replace the power seat control unit.
NO - Check for a short in the wire. If the wire is OK, faulty slide position sensor; replace the slide motor assembly.
Recline Position Sensor:
1. Remove the driver's power seat mounting bolts.
2. Disconnect the 6P connector from the recline motor/position sensor and the 12P connector from the power seat control unit.
3. Check for continuity between the No. 4 terminal of the recline position sensor and C12 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 4.
NO - Repair open in the BRN/BLK wire.
4. Check for continuity between the No. 5 terminal of the recline position sensor and C5 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 5.
NO - Repair open in the YEL/BLK wire.