CL V6-3.2L SOHC (2002)
Blower Motor: All Technical Service Bulletins
A/C - Blower Motor Inoperative
06-006
April 27, 2006
Applies To:
1999-03 3.2 TL - ALL 2001-03 3.2 CL - ALL
Blower Motor Does Not Work
(Supersedes 06-006, dated February 14, 2006 to update the information with the black bars and asterisks)
SYMPTOM
The blower motor does not work at all.
PROBABLE CAUSE
Poor connection at the blower motor caused by tension on the wiring harness.
CORRECTIVE ACTION
Install a blower motor sub harness.
PARTS INFORMATION
Blower Motor Subharness: P/N 04321-S0K-A00
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Operation Number:
6181A4
Flat Rate Time:
0.6 hour
Failed Part:
P/N 32150-50K-A04
Defect Code:
06401
Symptom Code:
01201
Template ID:
06-006A
Skill Level:
Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1.
Remove the glove box and cover:
^
199~03 3.2 TL: See page 20-66 of the 1999-03 3.2 TL Service Manual.
^
2001-033.2 CL: See page 20-64 of the 2001-03 3.2 CL Service Manual.
^
Online, enter keyword GLOVE, and select Glove Box Removal/Installation from the list.
*2.
Disconnect the brown 7P connector (C202) from the main harness. Remove the YEL/BLK wire terminal from cavity 3 of connector C202. Cut off
the terminal, and tape the remaining end of the wire to the harness.*
NOTE:
If necessary, refer to the terminal replacement section of the appropriate ETM for how to properly remove a terminal from a connector.
