CL V6-3.2L SOHC (2002)
*3.
Disconnect the 2P blower motor connector, cut off the connector, and tape the remaining ends of the wires to the pigtail. Then tape the pigtail to
the main harness.
4.
Disconnect the white 5P connector from the power transistor. Remove the BLU/RED wire terminal from cavity 4 of the power transistor
connector. Cut off the terminal, and tape the remaining end of the wire to the harness.
5.
Take the subharness, and insert the YEL/BLK wire terminal into cavity 3 of connector C202 and insert the BLU/RED wire terminal into cavity 4
of the power transistor connector. Tape both wires to the existing harness. Route the harness so there is no tension on the blower motor
connector.*
6.
Reconnect connector C202 and the power transistor connector, then connect the 2P connector on the new subharness to the blower motor.
7.
Verify the blower motor operates properly at all speeds.
8.
Reinstall the glove box and cover.
Disclaimer
