Integra L4-1797cc 1.8L DOHC (VTEC) (1996)
Antenna Motor: Testing and Inspection
POWER ANTENNA MOTOR / TEST
1. Remove the quarter trim panel (Hatchback) or trunk side trim panel (Sedan).
2. Disconnect the 3-P connector from the motor, and remove the connector from its clamp.
3. Check for power to the motor at the connector terminals:
*
There should be battery voltage between the WHT/RED (+) and BLK (-) terminals all the time.
*
There should be battery voltage between the YEL/GRN (+) and BLK (-) terminals only with the ignition and radio switched ON.
4. Test motor operation:
EXTEND: Connect battery power to the "A" and "B" terminals and ground the "C" terminal.
RETRACT: Then disconnect power from the "B" terminal.
5. If the motor fails to run or does not run smoothly, replace it.
Sticking Antenna:
The antenna sticks in either the up or down position.
1. Using the antenna wrench, remove the antenna nut, and spacer.