Integra L4-1797cc 1.8L DOHC (VTEC) (1996)
3. Remove the snap ring B with a snap ring pliers, then remove the pulley.
NOTE: Be careful not to damage the pulley and compressor during removal/installation. Once the snap ring B is removed, replace it with a new
one.
4. Remove the screw from the field coil ground terminal. Remove snap ring A with snap ring pliers, then remove the field coil.
NOTE: Be careful not to damage the field coil and compressor during removal/installation. Once snap ring A is removed, replace it with a new
one.
5. Install in the reverse order of removal, and:
-
install the field coil with the wire side facing down (see above).
-
clean the pulley and compressor sliding surfaces with non-petroleum solvent.
-
check the pulley bearings for excessive play.
-
make sure the snap rings are in the groove properly.
-
apply locking agent to the threads of the center bolt, and tighten it securely.
-
make sure that the pulley turns smoothly after it's reassembled.