Integra (RS, LS) L4-1834cc 1.8L DOHC PFI (1995)
ABS Light: Testing and Inspection
Warning Lamp Circuit
1. If anti-lock warning light does not go on when ignition is turned on, check the following items:
a. Blown anti-lock warning bulb.
d. Open circuit between No. 15 fuse and warning lamp.
c. Open circuit in blue/red lead between combination meter and control unit.
d. Bad control unit to body ground.
e. If not loose or disconnected, install new control unit and recheck.
2. If anti-lock brake warning light remains on after engine is started and LED on control unit does not blink any code or sub code, check for the
following:
a. Loose or poor connection of wire harness at control unit.
b. Faulty ABS 2 fuse.
c. Open circuit in white lead between ABS 2 fuse and control unit.
d. Open circuit in yellow/black lead between fail-safe relay and fuse No.17.
e. Short circuit in blue/red lead between combination meter and control unit.
f.
Open circuit in white/blue lead between alternator and control unit.
Fig. 5 Control Unit