ABS Resin Parts Paint Repair for Integra GS-R Sedan
8. Sanding, and cleaning
Lightly wet-sand the whole area to be painted with #400, #600 or #800 sandpaper. Blow off with compressed air, then clean with wax and grease
remover.
9. Top coating
-
Remove dust with a tack cloth before spraying.
-
Spray the top coat paint.
Spray until the primer surfacer is covered. The coating thickness should be 30-35 microns.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames or cigarettes.
-
Do not use high air pressure; use only an approved, 210 kPa (2.1 kgf/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
NOTE: F or the recommended top coat paint, refer to
"Example of repair materials".
Solid color: Color enamel + Color clear coat
Metallic color: Metallic enamel + Clear coat
10. Drying
After spraying, air-dry for about 10 minutes, then dry with an infrared dryer.
NOTE: Follow the paint manufacturer's specification to dry properly.