Integra GS-R Sedan L4-1797cc 1.8L DOHC (VTEC) MFI (1999)
Crankshaft: Service and Repair
Installation
OIL: Before installing the crankshaft, apply a coat of engine oil to the main bearings and rod bearings.
1. Install the thrust washers in the No. 4 journal of the cylinder block.
2. Insert bearing halves in the engine block and connecting rods.
3. Hold the crankshaft so rod journals for cylinders No. 2 and No. 3 are straight up.
4. Lower the crankshaft into the block, putting the rod journals into connecting rods No. 2 and No. 3.
Install the rod caps and nuts finger-tight.
5. Rotate the crankshaft clockwise, put journals into connecting rods No. 1 and No. 4, and install the rod caps and nuts finger-tight.
NOTE: Install caps so the bearing recess is on the same side as the recess in the rod.
6. Check rod bearing clearance with plastigage, then tighten the cap nuts in 2 steps.
1st step: 20 Nm (14 ft. lbs.)
2nd step:
B18B1 engine: 31 Nm (23 ft. lbs.)
B18C1, B18C5 engines: 44 Nm (33 ft. lbs.)
NOTE: Reference numbers on connecting rod are for big-end bore tolerance and do NOT indicate the position of piston in the engine.