Integra GS-R Sedan L4-1797cc 1.8L DOHC (VTEC) MFI (1999)
5.
Adjust the camber as needed.
Camber Adjustment, Double Wishbone Suspension
^
Loosen the subframe bolts. See the applicable service manual for more information.
^
Depending which way you need to shift the subframe, insert pry bars between the subframe and body at both the front and rear positions of the
subframe.
NOTE:
Be careful not to damage the vehicle. You could bend and damage the frame and/or body if you apply too much pressure.
^
Press on both pry bars to shift the subframe. It will move only a few millimeters. This should adjust the camber about 0.2 -0.5°.
^
While holding the subframe in place, have an assistant torque the subframe bolts to their proper torque.
Camber Adjustment, Strut Suspension
^
Raise the vehicle, and remove the front tires.
^
Loosen the damper pinch bolts and flange nuts.
^
Adjust the camber by moving the bottom of the damper within the range of the damper pinch bolt free play.
NOTE:
Some vehicles have special pinch bolts available that allow more adjustment. For more information, refer to the parts catalog.
^
Tighten the damper pinch bolts to the specified torque.
^
Reinstall the front wheels, and lower the vehicle. Bounce the front of the vehicle several times to stabilize the suspension.
6.
Test-drive the vehicle to make sure it no longer pulls. If the steering wheel is now off-center by more than 2 mm, go to REPAIR PROCEDURE C.