Integra GS-R Sedan L4-1797cc 1.8L DOHC (VTEC) MFI (1999)
NOTE:
Do not tip, lay sideways, or place the assembly upside down after removal from the housing. Do not pull apart the pump cam ring and the pump rotor
and vane assembly. Do not disassemble the flow control valve, the inlet joint, and the sub-valve.
6.
Remove the snap ring. Use a plastic hammer to tap out the pump shaft and bearing from the housing.
7.
With a press and a bearing separator tool (Snap-On Bearing Splitter CJ949 or equivalent), remove the bearing from the pump shaft. Discard the
bearing.