Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
Crankshaft: Testing and Inspection
End Play Inspection
CRANKSHAFT END PLAY
NOTE: End play should be inspected before removing crankshaft.
Push the crank firmly away From the dial indicator, and zero the dial against the end of the crank. Then pull the crank firmly back toward the
indicator; dial reading should not exceed service limit.
Crankshaft End Play:
Standard (New): 0.10 - 0.35 mm (0.004 - 0.014 inch)
Service Limit: 0.45 mm (0.018 inch)
-
If end play is excessive, inspect the thrust washers and thrust surface on the crankshaft. Replace parts as necessary.
NOTE:
-
Thrust washer thickness is fixed and must not be changed either by grinding or shimming.
-
Thrust washers are installed with grooved sides facing outward.
CONNECTING RODS END PLAY
NOTE: End play should be inspected before removing the crankshaft.
Connecting Rod End Play:
Standard (New): 0.15 - 0.30 mm (0.006 - 0.012 inch)
Service Limit: 0.40 mm (0.16 inch)
-
If out-of-tolerance, install a new connecting rod.
-
If still out-of-tolerance, replace the crankshaft.