Integra RS Sedan L4-1834cc 1.8L DOHC MFI (1997)
Valve Clearance: Adjustments
NOTE:
-
Valves should be adjusted cold; at a cylinder head temperature of less than 100°F (38°C).
-
Adjustment procedure is the same for both intake and exhaust valves.
-
After adjusting, retorque the crankshaft pulley bolt to 177 Nm (130 ft. lbs.).
PROCEDURE
1. Remove cylinder head cover.
2. Set the No. 1 piston at Top Dead Center (TDC). "UP" mark on the pulley should be at the top, and the TDC grooves on the pulley should align
with the TDC groove on timing belt back cover. TDC mark (painted white) on the crankshaft pulley should align with pointer on the timing belt
3. Adjust valve clearances on No. 1 cylinder.
-
Intake: 0.08 - 0.12 mm (0.003 - 0.005 inch).
-
Exhaust: 0.16 - 0.20 mm (0.006 - 0.008 inch).