Legend V6-2494cc 2.5L SOHC FI (1986)
3.
If the oil pressure light flashes when the cable moves, the cable's solder joint may be faulty. Replace the light panel. If the light doesn't flash, go on
to step 4.
4.
Disconnect the oil pressure switch, then check for an open circuit. Turn the ignition to "ON," and connect the YEL/RED wire to ground in three
places in the sequence shown. The oil light should go on each time; if it doesn't, find and repair the open. (If it flashes, turn the key off-and-on to
reset the flasher, and try again.)
PARTS INFORMATION
Indicator light panel:
'86 - 87 4-door
78145-SD4-A01
'88 4-door
78145-SG0-A02
'89 - 90 4-door
78145-SD4-A11
'87 - 90 Coupe
78145-SG0-A02
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Out-of-warranty: Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager. You must
request consideration, and get the DSM's decision, before starting work.
Operation number:
745140
Flat rate time:
Replace panel: 0.8 hour
Failed P/N:
78145-SD4-A01