MDX V6-3.7L (2007)
25. Remove the mounting bolts, then remove the solenoid valves.
26. Install new O-rings (two O-rings per solenoid valve) (E) on the reused solenoid valves.
NOTE: A new solenoid valve comes with new O-rings. If you install a new solenoid valve, use the O-rings provided on it.
27. Install shift solenoid valve D (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
NOTE: Do not hold the solenoid valve by the connector when installing the solenoid valve. Be sure to hold the solenoid valve body.
28. Install shift solenoid valve A (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
29. Install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the bracket of
shift solenoid valve A.
NOTE: Do not install shift solenoid valve C before installing shift solenoid valve A. If shift solenoid valve C is installed before installing shift
solenoid valve A, it may damage the hydraulic control system.
30. Install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the
accumulator body.
31. Connect the harness terminals to the solenoids:
^
YEL wire connector to shift solenoid valve A.
^
GRN wire connector to shift solenoid valve C.
^
RED wire connector to shift solenoid valve B.
^
ORN wire connector to shift solenoid valve D.
32. Install the shift solenoid valve cover, dowel pins, and a new gasket.
33. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with their filter side into the transmission
housing. Install the new O-rings over the ATF pipes.