MDX V6-3.7L (2007)
Relay Box: Service and Repair
Rear Fuse/Relay Box
Rear Fuse/Relay Box
Removal and Installation
SRS components are located in this area. Review the SRS component locations. and precautions and procedures before performing repairs or servicing.
Removal
1. Make sure you have anti-theft codes for the audio and navigation system (if equipped).
2. Make sure the ignition switch is OFF.
3. Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes.
4. Remove the left rear side trim panel.
5. Disconnect the connectors from the rear fuse/relay box (A).
6. Remove the mounting nuts and the rear fuse/relay box.
7. Carefully remove the relays by prying under the base of the relay.
NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.
Installation
1. Install the relays and connect the connectors to the rear fuse/relay box, then install the rear fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Connect the positive cable to the battery, then connect the negative cable to the battery.
4. Enter the audio and navigation system anti-theft codes, and set the clock.
5. Confirm that all systems work properly.
