MDX V6-3471cc 3.5L (2002)
Air Bag Control Module: Service and Repair
SRS Unit Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the driver's and front passenger's airbag connectors.
3. Disconnect the side airbag connectors.
4. Disconnect both seat belt tensioner connectors.
5. Remove the center console trim.
6. Pull down the carpet, then remove the Torx bolt (A) from the SRS unit.
7. Disconnect the connectors and remove the two Torx bolts (A), then pull out the SRS unit.
Installation
1. Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit; push it into position until it clicks.