NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Door opening trim
-
Hood
-
Parts related to steering column
-
Dashboard, etc.
2. Pull out and straighten the damaged area.
-
The collision damage may extend to the front pillar and roof panel (coupe) and roof rail (open top). Check for the damaged sections carefully
and pull them out to reshape.
-
Before pulling out the damaged sections, it might be necessary to heat the sections with an acetylene torch .
3. Remove the dashboard upper side extension.
-
Strike a punch in the center of the spot welds.
-
Drill the spot welds using a 10 mm (3/8") spot cutter.
-
Grind the MIG fillet welds using a rotary cutter.
-
Remove the dashboard upper side extension using a chisel.
4. Remove the dashboard upper.
-
Drill a punch in the center of the spot welds to the dashboard lower, front wheelhouse, and front pillar.
-
Drill the spot welds using a 10 mm (3/8") spot cutter.
-
Grind the MIG fillet welds using a rotary cutter.
-
Remove the remaining welding flanges using a chisel.
-
Remove the burrs from the drilled flanges using a disc sander.