NSX-T V6-3.2L DOHC (VTEC) (1997)
14. Pack the joint with joint grease included in the new joint boot set.
Grease Quantity: 120-130 g (4.2-4.6 oz)
15. Fit the inboard joint onto the driveshaft.
CAUTION: Reinstall the inboard joint in the original position on the rollers.
16. Adjust the length of the driveshafts to the figure below, then adjust the boots to halfway between full compression and extension. Bleed the air
from the boot, and check that the ends of the boot seat are in the grooves of the joint and driveshaft.
17. Install new boot bands on the boots, then bend both sets of locking tabs.