NSX V6-3.0L DOHC (VTEC) (1998)
5. Tension the timing belt between the pulleys in the sequence A to E as shown below.
6. Adjust the timing belt.
7. Install the lower cover and middle covers.
8. Install the crankshaft pulley, then tighten the pulley bolt.
9. Check the crankshaft pulley and the camshaft pulleys at TDC.
NOTE: To check the camshaft, try to insert 5.0 mm pin punches as shown when the camshaft is at TDC.
10. If a camshaft is not positioned at TDC, remove the timing belt and adjust the positioning following the procedure on page 6-18, then reinstall the
timing belt.
11. After installation, adjust the tension of each belt.