NSX V6-30L Manual Transaxle Differential Replacement Information
12. Select the proper 65 mm shim based on the following table.
-
If the measurement was less than 0.18 mm, install a thinner shim.
-
If the measurement was more than 0.229 mm, install a thicker shim.
13. After installing a thinner or thicker shim, be sure to recheck the measurement with plastigauge.
-
After installing a thinner shim: If the measured value is less than 0.18 mm, select the next thinner shim, and recheck. If the new value is more
than 0.229 mm, the selected shim is OK.
-
After installing a thicker shim: If the measured value is more than 0.229 mm select the next thicker shim, and recheck. If the new value is less
than 0.18 mm, take the shim you chose at the step 12.
14. Install the washer, thrust needle bearing, 65 mm shim, 112 mm shim, clutch plate, clutch disc, and spring plate. Position the 65 mm shim with the
thickness stamp mark facing up.