acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Customer Interest for Alignment:|06-034|Page 1277 > < Customer Interest for Alignment:|06-034|Page 1275
Page 6
background image

NOTE:

Do this repair procedure if, after doing step 10 of the test-drive, the vehicle pulled in the opposite direction after you swapped the front tires.

1. Swap wheels 2 and 4 on the passenger's side of the vehicle, and test-drive again.

^

If the pull goes away, replace the tire on wheel 2, then go to step 3.

^

If the pull does not go away, put wheels 2 and 4 back to their original positions, and go to step 2.

2. Swap wheels 1 and 3 on the driver's side of the vehicle, and test-drive again.

^

If the pull goes away, replace the tire on wheel 1, then go to step 3.

^

If the pull does not go away, use a known-good tire in position 1 and continue the diagnosis.

3. Use your diagnostic worksheet to fill in the following table and build your 15-digit DTC.

REPAIR PROCEDURE B

Customer Interest for Alignment:|06-034|Page 1277 > < Customer Interest for Alignment:|06-034|Page 1275