RDX L4-2.3L Turbo (2008)
2. Go into the System Diagnostic Mode, select Detail Information & Setting, then select Version.
Is the Program Flash Version 1.70.00 KA or higher?
Yes - This service bulletin does not apply. Continue with normal troubleshooting.
No - Go to REPAIR PROCEDURE.
REPAIR PROCEDURE
1. Start the engine.
2. Eject the navigation DVD. Refer to the applicable service manual for the DVD location, ejecting, and handling instructions.
3. With the engine running, insert the correct patch CD into the navigation DVD slot with its label side up. If needed, close the door over the slot.
4. Allow the navigation system to download the patch CD. The navigation screen may go blank or display a brief error message before a downloading
message appears, then it changes to an updating software progress bar.
5. After the CD finishes loading, the navigation system may reboot to the disclaimer screen, or display DVD Disc reading error (incorrect DVD Disc)
on the screen. Remove the patch CD, and insert the original navigation DVD.
NOTE:
If the Factory in-line diagnostic screen appears, refer to the applicable service manual for the symptom System always comes up in in-line diagnostic
mode.
6. Turn the ignition switch to LOCK (0), wait 30 seconds, then restart the engine.
7. Do the map-matching and verify that the navigation system works properly by test-driving the vehicle on a mapped road until the road name appears
