RDX AWD L4-2.3L Turbo (2010)
Compressor Clutch: Service and Repair
A/C Compressor Clutch Overhaul
Special Tools Required
-
A/C Clutch Holder Robinair 10290 or Kent-Moore J37872, commercially available
-
A/C Clutch Holder Honda Tool and Equipment ACT499A, commercially available
1. Remove the center nut (A) while holding the armature plate (B) with a commercially available A/C clutch holder (C).
2. Remove the armature plate (A) and the shim(s) (B), taking care not to lose the shim(s). If the clutch needs adjustment, increase or decrease the
number and thickness of shims as necessary, then reinstall the armature plate, and recheck its clearance See: Testing and Inspection.
NOTE:
-
The shims are available in three thicknesses: 0.1 mm, 0.2 mm, 0.4 mm, and 0.5 mm.
-
Do not pry on the armature plate with screwdrivers or similar tools. Prying damages the armature plate and the rotor pulley.
-
When replacing the clutch set, place a trial stack of shims, 1 mm total thickness, on the A/C compressor shaft. Install the armature plate, and
check its clearance See: Testing and Inspection. If the clearance is not with specification, add or subtract shims as needed