RDX AWD L4-2.3L Turbo (2010)
Hold both connector halves, and press them firmly together until the projection (A) of the sleeve-side connector clicks.
Opening the SRS Unit Shorting Connectors for Diagnosis
Special Tools Required
-
SRS Short Canceller 070AZ-SAA0100
NOTE:
-
To prevent damage to the connector cavity, insert the short canceller straight into the cavity from the terminal side.
-
Before installing the short canceller, wash it with electrical contact cleaner or neutral detergent, then dry it with compress air.
-
Do not use the short canceller if it is damaged.
-
Make sure to remove the short canceller before reconnecting the SRS unit connector.
-
Some systems store data in memory that is lost when the battery is disconnected. Before disconnecting the battery, refer to Battery Terminal
Disconnection and Reconnection See: Starting and Charging/Battery/Service and Repair/Procedures.
When SRS unit connectors A (28P), B (28P), or C (16P) are disconnected, a short circuit is automatically created in the connector to prevent accidental
deployment of an airbag. The circuit may need to be open when diagnosis is done on the system. Insert a short canceller (T/N 070AZ- SAA0100) in the
specified cavities when necessary to keep the circuit open for diagnosis.