RDX AWD L4-2.3L Turbo (2010)
Auxiliary Power Outlet: Service and Repair
Front Accessory Power Socket Test/Replacement
Front Accessory Power Socket Test/Replacement
NOTE: If both the front and console accessory power sockets do not work, check the No. 35 (7.5 A) fuse in the under-dash fuse/relay box or poor
connection at G502.
1. Remove the center console panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installationand audio pocket See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhaul.
2. Disconnect the 2P connector (A) from the front accessory power socket (B).
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I).
5. Measure the voltage between power accessory socket 2P connector terminal No. 1 and body ground. There should be battery voltage.
-
If there is battery voltage, go to step 6.
-
If there is no battery voltage, check for:
-
Blown No. 29 (15 A) fuse in the under-dash fuse/relay box.
-
Faulty front accessory power socket relay.
-
An open or high resistance in the wire.
6. Measure the voltage between terminals and No.1 No. 2. There should be continuity.
-
If there is battery voltage, go to step 7.
-
If there is no battery voltage, check for:
-
Poor ground (G503).
-
An open or high resistance in the ground wire.
7. Gently press tabs (A) and remove the socket (B).