RDX AWD L4-2.3L Turbo (2010)
9. Pry the lock tabs of the lock washer (E) on the transmission range switch (F), hold the selector control shaft (G) with a 6.0 mm wrench, and loosen
the locknut (H).
10. Remove the locknut and lock washer, then remove the transmission range switch (two bolts).
11. With a 6.0 mm wrench, turn the selector control shaft fully counterclockwise (viewed from the shaft end) to the P position. Turn the selector
control shaft back two click-stopped positions so that it is in the N position.
12. Set a new transmission range switch (A) to the N position. The transmission range switch clicks in the N position, and the selector control shaft
hole (B) aligns with the N position line (C).