RL V6-3.5L (2007)
Template ID:
07-061A
Skill Level:
Repair Technician
REPAIR PROCEDURE
1.
Remove the right upper fender trim, and detach the washer reservoir tube from the bottom side of the trim.
^
Refer to page 20-159 of the 05-08 HL Service Manual, or
^
Online, enter keyword UPPER and select Upper Fender Trim Replacement from the list.
2.
Drain the P/S fluid.
NOTE:
Take care not to spill any fluid. Wipe off any spilled fluid immediately.
^
Refer to page 17-13 of the service manual, or
^
Online, enter keywords STEERING FLUID, and select Power Steering Fluid Check/Replacement from the list.
3.
Check the condition of the drained fluid:
^
If the fluid is contaminated, dark, or discolored, discard it; do not reuse it.
^
If the fluid is light colored with no contamination, save it in a covered container. It will be reused in step 23.
4.
Reinstall the return hose on the P/S reservoir, and attach the reservoir to its mount. If the hose clamp on the return hose is damaged, replace it.
5.
Remove the battery trim and the left upper fender trim:
^
Refer to page 20-159 of the service manual, or
^
Online, enter keyword UPPER and select Upper Fender Trim Replacement from the list.
6.
Remove the engine cover (two clips).