RL V6-3.5L (2007)
24.
Start the engine, run it at a fast idle, and turn the steering wheel lock-to-lock several times. This will bleed any air from the P/S system.
25.
Stop the engine, then recheck the fluid level, and add more if needed. Do not fill the reservoir above the upper level line.
26.
Reinstall the right upper fender trim, and make sure the washer reservoir tube is attached to the bottom of it. Use the extra clips from the kit to
replace any damaged ones.
27.
Center-punch a completion mark above the fifth character of the engine compartment VIN.
Disclaimer