RL V6-3.5L (2007)
69. Disconnect the APP sensor 6P connector, and measure voltage between body ground and PCM connector terminal D2 with the ignition switch ON
(II).
Is there about 5 V?
YES - Replace the accelerator pedal module.
NO - Go to step 70.
70. Turn the ignition switch OFF.
71. Jump the SCS line with the HDS.
72. Disconnect the APP sensor 6P connector.
73. Disconnect PCM connector D (17P).
74. Check for continuity between PCM connector terminal D2 and body ground.
Is there continuity?
YES - Repair short in the wire between the PCM (D2) and the APP sensor.
NO - Update the PCM if it does not have the latest software, or substitute a known good PCM, then recheck. If the symptom/indication goes away
with a known good PCM, replace the original PCM.
75. Measure voltage between PCM connector terminal E12 and body ground.
Is there about 5 V?
YES - Update the PCM if it does not have the latest software, or substitute a known good PCM, then recheck. If the symptom/indication goes
away with a known good PCM, replace the original PCM.
NO - Go to step 76.