RL V6-3.7L (2009)
12. Pull the outer handle (A) out, and back as shown to remove it from the door. Take care not to scratch the door.
13. Release the hooks (A, B, C), then remove the outer handle front seal (D) and the outer handle rear seal (E).
14. Remove the outer handle base (A).
-1 Remove the nut.
-2 Release the tab (B), and slide the outer handle base forward to release the special bolt (C) from the door panel.
-3 Detach the connector clip (D) and the harness clip (E) from the outer handle base.
15. Remove the joint bushing (A) from the outer handle (B), then replace it with a new one.
16. Install the handle in the reverse order of removal, and note these items: