RL V6-3.7L (2009)
Air Door Actuator / Motor: Service and Repair
Driver's Cool Vent Control Motor Replacement
Driver's Cool Vent Control Motor Replacement
1. Remove the driver's dashboard undercover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation
2. Disconnect the connectors (A) from the adaptive front lighting control unit, the electronically controlled power steering control unit, and the
daytime running lights control unit. Remove the relay (B), the bolt, and the self-tapping screws, then remove the bracket (C).
3. Disconnect the 5P connector (A) from the driver's cool vent control motor. Remove the self-tapping screws and the driver's air mix control motor
(B).
4. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.