RL V6-3.7L (2009)
Alarm Module: Service and Repair
Immobilizer Control Unit-Receiver Replacement
Immobilizer Control Unit-Receiver Replacement
1. Remove the driver's dashboard undercover, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation and the driver's dashboard lower cover. See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Driver's Dashboard Lower Cover Removal/Installation
2. Remove the steering column covers. See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Column Removal and
Installation
3. Remove the ignition switch knob. See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition Switch/Service
and Repair
4. Disconnect the 7P connector (A) from the immobilizer control unit-receiver (B).
5. Remove the two screws and the immobilizer control unit-receiver from the ignition key cylinder (C).
6. Install the immobilizer control unit-receiver in the reverse order of removal.
7. After replacement, the immobilizer control unit-receiver must be registered in IMMOBILIZER with the HDS (all keys and the PCM code are
required). See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Testing and Inspection/Programming and
Relearning