RL V6-3.7L (2009)
10. Install the new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end into the transmission
housing and 8 x 25.2 mm ATF pipe (D).
11. Install new O-rings (E) over the ATF joint pipes.
12. Install A/T clutch pressure control solenoid valve C.
13. Check the connector for rust, dirt, or oil, then connect the connector securely.
14. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
15. Install the battery base.
16. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement