RL V6-3474cc 3.5L (1998)
24. Pull the knuckle outward, and remove the driveshaft outboard joint from the knuckle by tapping the driveshaft end with a plastic hammer, then
remove the steering knuckle.
NOTE: Replace the bearing with a new one after removal.
25. Carefully clamp the caliper bracket mount section of the knuckle in a vise with soft jaws.
26. Separate the hub from the knuckle using a commercially available hub puller.
CAUTION:
-
Hold the steering knuckle securely so it does not slip out of the vise from the impact.
-
Take care not to distort the splash guard.
27. Remove the splash guard.