RL V6-3474cc 3.5L (1998)
2. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, make the input tests as shown in the table at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the power window master switch must be faulty; replace it.
NOTE:
-
Before testing, go to the Troubleshooting Guide. Be sure to go through self-diagnosis function modes 1 and 2.
-
All connector views are from the wire side of female terminals unless otherwise noted.
Multiplex Control Unit (Passenger's):
1. Remove the right kick panel.
2. Disconnect the 22P and 26P connectors, then remove the passenger's unit.