RL V6-3474cc 3.5L (1998)
REPAIR PROCEDURE
1.
Protect the roof by applying a strip of 2-inch-wide masking tape along the outer edge of the windshield molding.
2.
Pull up the outer edge of the molding, and use scissors or an X-acto knife to remove its entire inner lip.
3.
With an 0-ring pick or similar tool, pull up the outer edge of the molding and apply 3M Black Super Silicone Sealant under it, along the A-pillars
and the upper edge of the windshield.
4.
Push down on the molding, and smooth it out until it sits flush with the roof.
5.
Wait 5 minutes, then remove the masking tape.
6.
Clean up any excess sealant with 3M General Purpose Adhesive Cleaner.
DISCLAIMER