RSX L4-2.0L (2005)
Air Bag: Service and Repair
Side Airbag
Side Airbag Replacement
NOTE: Review the seats replacement procedure in the body section before performing repair or service.
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the side airbag harness 2P connector (A).
3. Remove the seat assembly and seat-back cover.
4. Remove the mounting nut (A) and the side airbag (B).
Installation
NOTE: Be sure to install the harness wires so that they are not pinched or interfering with other parts.
NOTE:
-
If the side airbag lid is secured by a tape, remove the tape.
-
Do not open the lid of the side airbag cover.
-
Use new mounting nuts tightened to the specified torque when you replace a side airbag.
-
Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.