RSX L4-2.0L (2005)
16. Remove the snap ring (A) and the splash guard (B) from the knuckle (C).
17. Press the wheel bearing (A) out of the knuckle (B) using the special tools and a press.
18. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
19. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the special tool, and a press. Place the wheel
bearing on the knuckle with the pack seal side facing (E) (metal color) toward the inside. Be careful not to damage the sleeve of the pack seal.