RSX L4-2.0L (VTEC) (2002)
clearing fails, repeat the process two more times. If the DTC clearing fails again, check for set SRS DTCs, and troubleshoot them with the
appropriate service manual.
REPAIR PROCEDURE B: OPDS SENSOR REPLACEMENT
1.
Remove the seat-back cover from the front passenger's seat:
^
Using the appropriate service manual, go to section 20 (Body), and do the removal steps under Front Seat Cover Replacement, or
^
Online, enter keyword SEAT COVER, then select Front Seat Cover Replacement from the list, and do the removal steps in the procedure.
2.
Slide the seat-back cushion (foam) off the seat-back frame. (The OPDS sensor is built into the seat-back cushion.)
3.
Slide a new seat-back cushion over the seat-back frame. Make sure the cushion is centered.
4.
Reinstall the seat-back cover:
^
Using the appropriate service manual, go to section 20 (Body), and do the installation step under Front Seat Cover Replacement, or
^
Online, enter keyword SEAT COVER, then select Front Seat Cover Replacement from the list, and do the installation step in the procedure.
5.
Reinitialize the OPDS unit:
^
To reinitialize with the HDS, go to Initializing the OPDS Unit: HDS Method in this service bulletin.
^
To reinitialize with the SCS service connector, go to Initializing the OPDS Unit: Manual Mode in this service bulletin.
Disclaimer