RSX L4-2.0L (VTEC) (2002)
2.
Move the auto-tensioner pulley wheel with a wrench to relieve the drive belt tension.
3.
Slip the drive belt off of the power steering pump pulley.
4.
Using the special tool, remove the pulley nut and the pulley.
5.
Install a new power steering pump pulley, then loosely install the pulley nut.
6.
Hold the pulley with the special tool, and torque the pulley nut to 64 N.m (47 lb-ft).
7.
Move the auto-tensioner with a wrench, and install the drive belt.
8.
Clip the power steering pump reservoir onto the holder bracket.