TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
ABS Light: Testing and Inspection
Warning Lamp Circuit
1. If anti-lock warning light does not go on when ignition is turned on, check the following items:
a. Blown anti-lock warning bulb.
b. Open circuit in yellow lead between No. 1 fuse and combination meter.
c. Open circuit in blue/red lead between combination meter and control unit.
d. Bad control unit to body ground.
e. If not loose or disconnected, install new control unit and recheck.
2. If anti-lock brake warning light remains on after engine is started and LED on control unit does not blink any code or sub code, check for the
following:
a. Loose or poor connection of wire harness at control unit.
b. Faulty ABS 2 fuse.
c. Open circuit in white lead between ABS 2 fuse and control unit.
d. Short circuit in blue/red lead between combination meter and control unit.
e. Open circuit in white/blue lead between alternator and control unit.
3. Control unit can indicate up to three trouble codes. If LED does not light, repeat steps 1 through 2.
4. If required, turn ignition switch off, then turn on to read LED.
5. After repair is completed, disconnect ABS B2 fuse for three seconds to erase control unit memory, then turn ignition switch on to recheck.
6. Memory is erased if connector is disconnected from control unit or control unit is removed from body.
