TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
Air Bag(s) Arming and Disarming: Service and Repair
1. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming
procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. Disconnect battery negative cable, then disconnect positive cable. After disconnecting battery negative and positive cables, wait at least 3
minutes, with ignition switch in Off position, before disconnecting any air bag electrical connectors. This will allow the capacitor in the
air bag system back-up circuit to discharge.
Fig. 4 SRS Red Short Connector To Driver's Side Air Bag Connector
3. For driver's side air bag, proceed as follows:
a. Remove access panel located below air bag, then remove red short connector from panel, Fig. 4.
b. Disconnect electrical connector located between air bag and cable reel.
