TL L5-2451cc 2.5L SOHC MFI (1997)
Hazard Flasher Relay: Testing and Inspection
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing
repairs or service.
1. Remove the turn signal/hazard relay from the under-dash fuse/relay box.
Turn Signal/Hazard Relay Input Test
2. Inspect the relay and fuse/relay box socket terminals to be sure they are all making good contact.
^ If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
^ If the terminals look OK, make the following input tests at the fuse/relay box socket.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the turn signal/hazard relay must be faulty; replace it.
