TL V6-3.2L (2004)
Repairs and Inspections Required After a Collision: Service and Repair
Component Replacement/Inspection After Deployment
NOTE: Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious
deployed parts (seat belt tensioners, front impact sensors, side impact sensors, etc.). See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions
After a collision where the seat belt tensioners deployed, replace these items:
-
SRS unit
-
Seat belt tensioners
-
Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed airbag(s)
-
Seat belt tensioners
-
Front impact sensors
After a collision where the side airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side airbag(s)
-
Side impact sensor(s) (first) for the side(s) that deployed
After a collision where the side curtain airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side curtain airbag(s)
-
Side impact sensor(s) (first) for the side(s) that deployed
-
Side impact sensor(s) (second) for the side(s) that deployed
-
Roof trim
-
Center pillar upper trim
-
Front grab handle
-
Any related trim clips
Replace the clips on these parts even if they look undamaged:
-
Front pillar trim
-
Center pillar trim
-
Rear pillar trim
-
Front grab handle
-
Sunvisor
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. According to the degree
of damage, replace components as needed.