TL V6-3.5L (2007)
^ Updating with the HIM
- HIM Updating in Pass-Thru Mode (pg. 12)
- HIM Updating in Storage Mode (pg. 13)
- Diagnosing HIM Error Codes (pg. 15)
- HIM Self-Test (pg. 15)
NOTE:
^ Whenever you install a new, reprogrammable control unit/module, check that it has the latest software, and update it if needed.
^ AcuraLink control units can only be updated with the GNA600. For information on updating the AcuraLink control unit, refer to Service Bulletin
07-027, Updating the AcuraLink Control Unit.
^ Before doing a PCM update on one of the vehicles listed below, refer to Service Bulletin
09-009,
Disconnect the AcuraLink Update Connector Before Updating the PCM.
- 2009 RL w/Tech Package (From VIN JH4KB266.9C000001 thru JH4KB266.9C002248)
- 2009 TL w/Tech Package (From VIN 19UUA86..9A000001 thru 1 9UUA86..9A006223)
- 2009 TSX w/Tech Package (From VIN JH4CU2...9C000001 thru JH4CU2...9C033097)
WARRANTY CLAIM INFORMATION
Skill Level: Repair Technician
Refer to the specific service bulletin for the symptom you are repairing.
QUESTIONS ABOUT THE UPDATING EQUIPMENT OR THE INTERACTIVE NETWORK
For questions about the Honda-supplied updating equipment, call American Honda's Special Tools hotline.
For questions about the iN, call the iN Support Center.
REQUIRED TOOLS AND EQUIPMENT
NOTE:
Updating for most control units/modules can be done with any of the following tools. Updating for AcuraLink control units can only be done with the
GNA600.