TL AWD V6-3.7L (2010)
4. Insert the new wheel bolt (A) into the hub (B) while aligning the splined surfaces (C) on the hub hole with the wheel bolt. Adjust the measurement
(D) with the washers (P/N 94101-14800 or equivalent) (E), then install a nut (P/N 90304-SHJ-A91 or equivalent) (F) hand-tight.
NOTE:
-
Degrease the area around the wheel bolt and the threaded section of the nut.
-
Make sure the wheel bolt is installed vertically in relation to the hub disc surface.
-
Do not install the nut and the washers that have been used as tools on a vehicle.
5. Tighten the nut until the wheel bolt is drawn fully into the hub. Do not exceed the maximum torque limit. Make sure there is no gap (G) between
the bolt and the hub.
6. Install the rear brake disc/drum See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Brake Disc
Replacement.
NOTE:
-
If you cannot tighten the wheel nut to the specified torque when installing the wheel, replace the rear hub bearing unit as an assembly.
-
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
