TL FWD V6-3.5L (2009)
Handling Wires and Harnesses
-
Secure wires and wire harnesses to the frame with their respective wire ties at the designated locations.
-
Remove clips carefully; don't damage their locks (A).
-
After installing harness clips, make sure the harness doesn't interfere with any moving parts.
-
Keep wire harnesses away from exhaust components and other hot parts, from sharp edges of brackets and holes, and from exposed screws and
bolts.
-
Seat grommets in their grooves properly (A). Do not leave grommets distorted (B).
Testing and Repairs
-
Do not use wires or harnesses with broken insulation. Replace them or repair them by wrapping the break with electrical tape.
-
Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage in SRS wiring or terminals, replace the harness.
-
After installing parts, make sure that no wires are pinched under them.
-
When using electrical test equipment, follow the manufacturer's instructions and those described in this data.
-
If possible, insert the probe of the tester from the wire side (except waterproof connector).