ZDX V6-3.7L (2010)
Repairs and Inspections Required After a Collision: Service and Repair
SRS Component Replacement/Inspection After Deployment
NOTE:
-
Before doing any SRS repairs, Clear the DTCs with the HDS See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes, for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.).
-
Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting.
-
After a vehicle collision, do the ODS unit operation check See: Air Bag Systems/Testing and Inspection/Component Tests and General
Diagnostics/ODS Unit Operation Check.
-
After a vehicle collision, inspect the front seat active head restraints See: Body and Frame/Seats/Head Rest/Testing and Inspection.
After a collision where the seat belt tensioners deployed, replace these items:
-
SRS unit
-
Seat belt tensioners
-
Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed airbag(s)
-
Seat belt tensioner(s)
-
Front impact sensor(s)
-
Dashboard
After a collision where a side airbag deployed, replace the items for the side(s) that deployed:
-
SRS unit
-
Side impact sensor(s) (first)
-
Side impact sensor(s) (second)
-
Rear safing sensor
-
B-pillar lower trim
-
Front seat assembly (Impact side)
-
Seat belt tensioner(s)
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
-
SRS unit
-
Deployed side curtain airbag(s)
-
Seat belt tensioner(s)
-
Side impact sensor(s) (first)
-
Side impact sensor(s) (second)
-
Rear safing sensor
-
A-pillar trim
-
B-pillar upper trim
-
Quarter pillar trim
-
Front grab handle
-
Rear grab handle
-
All related trim clips
-
Sunvisor
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components
as needed.
