ZDX V6-3.7L (2010)
- If the No.9 fuse is OK, go to REPAIR PROCEDURE.
On ZDX, check for a blown No.11(7.5 A) mini fuse in the auxiliary under-hood fuse/relay box.
A 7.5 A micro fuse will fit in the No.11 slot, but won't provide the necessary electrical contact. This could lead to a misdiagnosis, because this poor
contact will eventually set the same DTC (B1192) and MID message (CHECK BATTERY SENSOR) as if the battery sensor has failed.
- If the No.11 fuse is blown, or is a micro fuse, replace it with a 7.5 A mini fuse. Clear the DIG and the MID message, then recheck the system. If the
fuse blows again, troubleshoot its cause.
- If the No.11 fuse is OK, and a 7.5 A mini fuse is in the slot, go to REPAIR PROCEDURE.
REPAIR PROCEDURE
1. Make sure the computer memory saver is fully charged and ready to use.
2. Write down the anti-theft code for the audio system or the audio/navigation system.
3. Connect the computer memory saver to the data link connector (DLC).
4. Make sure the ignition switch is in LOCK (0). On ZDX models with the keyless access system, make sure that the power mode is set to VEHICLE
OFF.
